स्थापित करें मुफ्त इकाई रूपांतरण!
स्थापित करें मुफ्त इकाई रूपांतरण!
स्थापित करें मुफ्त इकाई रूपांतरण!
|
स्थापित करें मुफ्त इकाई रूपांतरण!
- Ruger American Rimfire | Gunner Forum
The receiver is a tubular piece of steel and mounts to the stock with 2 allen screws There are embedded aluminum pieces in the stock that fit into slots in the bottom of the receiver This provides solid bedding and free floats the barrel for its full length The safety is mounted on the tang - forward to fire and back for safe If the action is cocked, the bolt can be worked with the safety
- Freedom Arms Model 1997 . 224-32 FA Revolver - Gunner Forum
Freedom Arms offers the 224-32 FA in various barrel lengths, but the test gun wore a ten inch barrel, which is my favorite length for a varmint revolver As expected, tolerances were very tight on this Model 97, as they are on all Freedom Arms products
- 357 Dies | Gunner Forum
I set up my 357 dies the other night and when I seat the bullet it crimps at the same time This is a 4 dies set and has a seperate crimp die Should it be crimping? It's a heavy crimp too :? My 45 acp dies don't do that
- Savage 99 308 - Gunner Forum
I'm looking to reload for my 99 in 308 Anyone out there have a favorite load? Also what should the O A bullet length be I tried using the OA recommended in my reloading book and but the bullets wouldn't feed into the rotary block magazine Thanks for any help
- What About This Revolver? | Gunner Forum
Are any of you guys aware of the 500 S W Magnum being significantly shortened and utilized in any platforms? I thought that the 500 S W being shortened to the same case length as a 44 Magnum - 1 285 inches (32 6 mm) - would be handy to have in a 5 shot revolver ala Super Redhawk Alaska or a
- Remington 1100 | Gunner Forum
Have had this little jewel since 1983, I use to hunt on Fort Hood before they got picky and had some really long shots for Dove, so I was shooting high base high brass shells in those days They were hard on the old shoulder, so I had a recoil pad put on but the so call gunsmith never cut the
- Ive found out. . . | Gunner Forum
I would back the load down a good 5 gr or more and see if the sticky bolt stops I wouldn't change brass if that is a hot load , you could end up with a real problem Take a case fired in your gun and see if a new bullet will drop in case to see if the neck is thickness is ok for your gun and check brass length also
- Lever Action Rifles | Page 3 | Gunner Forum
Lever action lock Cowboydan Jul 10, 2013 13 10K Aug 25, 2013 by KS95B40 1 6 Lever Action Rifles 2 8K posts 1 1M views Lever Action Rifle Forum - Lever Action Rifle topics and discussion Join Community Grow Your Business
|
|
|